RockBoard MOD 1 V2 - All-in-One TRS & XLR, IEC & Barrel Patchbay

The MOD 1 V2 Patchbay is the simplest solution for combining ALL pedalboard connections into ONE central access point. Setup, for example, at a gig, is done in seconds!

The MOD 1 V2, with its innovative pass-through design, was specifically developed for versatile musicians. You can use the MOD 1 V2 to position some of your pedals in the front end before the amp (distortion, compressor, etc.) and some in the effects loop (e.g., reverb, delay) (4-cable method). The XLR pass-through connection can be used, for example, as a signal output from the pedalboard to the mixer or PA.

Suitable for almost all pedalboards (except the compact DUO series) with one or more MOD slots, the All-In-One Patchbays offer the possibility to organize all necessary cable connections in one practical module. All pedals can remain neatly wired under the board and all connections to and from your effects setup can be organized in one practical module.

The removable front panel makes it possible to use this ingenious module with pedalboards from other manufacturers, e.g. with our 'Mounting Rack'.

Specs:

• All-in-one patchbay for pedalboards
  
• Suitable for MOD slots in RockBoard pedalboards
  
• Compatible with a wide range of other pedalboards
  
• Acts as a central access point to your effects setup
  
• Establishes clear cable routes to and from the pedalboard
  
• Removable front panel for mounting on or under pedalboards
  
• 5 x 6.3 mm TRS thru
  
• 1 x XLR thru (male front / female rear)
  
• 1 x DC 2.1 x 5.5mm barrel thru
  
• 1 x AC IEC thru (male front / female back)
  
• All connections mirrored on the back
  
• Dimensions excl. front panel (W x D x H): 160 x 60 x 33 mm
  
• Front panel dimensions (W x H): 175 x 48 mm
  
• Weight: 450 g
  
• Including mounting screws, lock nuts and TX key